Got RSI from coding at job circa 2016 and bought this baby for $350. I’m using it as long as possible, but I would love a metal splittyboi
Thumb clusters are life!
Got RSI from coding at job circa 2016 and bought this baby for $350. I’m using it as long as possible, but I would love a metal splittyboi
Thumb clusters are life!
there were a couple projects at one point that did flexible replacement PCBs for the Advantage2 that would upgrade the board to QMK (Stapelberg?) – could use it as an excuse to update switches and keycaps?
These are separate things. You can easily replace the SmartSet controller in the KA2 with a KinT controller with QMK. The key wells and thumb clusters are connected to the controller with removable ribbon cables. The swap-out takes maybe 5 minutes.
Kinesis offered replacement flex PCB and key wells in the past, so that you could replace your switches. They don’t sell them anymore and instead you have to go through an expensive UpgradeKeyboards.com build.
Do you know of any projects that include the PCBs for the switches? I’ve only found the controller PCBs so far.
don’t remember anything recently (was under the impression BastardKB had something but I can’t find anything on the website) – and it seems most people working on Dactyl variants usually end up just using the Amoeba PCBs because they’re easier to source …
I’m in the works on a solution with hotswap but I’m not there just yet.
Interested to see how that works. What I’ve heard so far from diy dactyl/Skeletyl builds is that the curvature of the flexible PCB makes some glue or similar necessary.