Hi all,

I have an idea in my head, but I’m a cable short, and looking for suggestions.

24-key split-ortho (2 keys per finger, where you press both top and bottom keys simultaneously to get the home row key), with per-key RGB and OLED display on the left side. But…

I’d like to run this off a single BlackPill controller on the left hand side, and use a CAT6 cable to bridge the two sides.

CAT6 has 4 twisted pairs, so 8 cables. If I run a 4x3 matrix then that’s 7 cables. Plus another for the VCC for the RGB. But then no more for the DIN/DOUT for RGB. GND should be fine as I can earth the right hand side separately, but I’m missing a cable if I want RGB.

Are there any suggestions on how I might be able to get around my challenge?

  • Andy@lemmy.worldOPEnglish
    2·
    1 year ago

    Thank you. It was specifically the CAT6 I was Looking to use, as you can get an ultra thin patch cable, and it will clip in (so reduced risk of shorting the controller). Maybe I need to go without RGB? 😭