Title basically.
Obviously, cold nozzle + filament on it from my last print = the printer thinks the nozzle is lower than it actually is.
Preheating the nozzle helps some, but if I want true consistency I need to mechanically whipe the nozzle/grab the bit of plastic that oozes out with a pair of needle nose pliers.
I know nozzle brush mods are a thing, but aren’t the hard on your nozzle? Does anyone have any alternative ideas?
Sorry I just realized the way I described everything was actually pretty confusing. After every print I run a clean macro that moves the nozzle up front and heats to 230 and sits there. After about 10 minutes I wipe it then have a clean complete macro to cool down and move it back to the center. Then I start a print and the homing etc is all done at a lower temp, I can’t remember if it’s static or nozzle temp -75c or something