I’ll be getting a used JVC L-A31 tomorrow and it comes with a replacement stylus. I suppose ill be installing it right away as I don’t know how old the one that is currently installed is. Any tips on how to make sure I don’t break the tonearm or cartridge? I only replaced the stylus and cartridge once on a very cheap record player which uses one of those 3 euros cartridges, will the procedure be similar or should I expect some further complications?

  • jtablerd@lemmy.worldEnglish
    1·
    11 months ago

    Should be pretty straightforward, just be gentle with the tonearm and pulling the wires off the old one. Audio Technica VM95E should be a fine one and not too costly, with a pretty good upgrade path if you decide to down the road

    • brozzsama@lemmy.worldOPEnglish
      1·
      11 months ago

      Thanks for the answer. Actually I think my post was a bit confusing, I will only be changing the stylus, do I still need to remove the cartridge for this operation as well? Or can I pull it off directly?

      I’ll keep in mind your suggestion for the upgrade!

      • jtablerd@lemmy.worldEnglish
        1·
        11 months ago

        Oh sorry it should pop right off you’ll just need to replace with the factory one assuming that its the stock cartridge (and you can find one)

        • brozzsama@lemmy.worldOPEnglish
          2·
          11 months ago

          Awesome. Yes the previous owner is selling an unopened new stylus along with the player, I assume they bought it to have a spare one and never used it.

          • brozzsama@lemmy.worldOPEnglish
            1·
            11 months ago

            In case anyone needs it for future reference the stylus on the original Z1-S cartridge just comes right off with a slight horizontal pull away from the cartridge. It is a lot easier than replacing the cartridge on cheaper players such as low-end Crosleys (eg. https://youtu.be/XtFBIa39U0U), so don’t expect the procedure to be similar.