you’re welcome :)
or since you probably are from Denmark since you mentioned Danish in your other comments:
🇩🇰 bare hyggelig, og håper du fikk løst problemet ditt 🇳🇴
you’re welcome :)
or since you probably are from Denmark since you mentioned Danish in your other comments:
🇩🇰 bare hyggelig, og håper du fikk løst problemet ditt 🇳🇴
not to be that guy . but have you tried to search for an answer?
https://github.com/flatpak/flatpak/issues/4435
first hit on “flatpak question marks”… it’s due to the font you use in the terminal does not support or not fully support Unicode characters or your locale settings are not correct.
hope this helps and answers your question :)
(edit, lost part of a sentence)
here is a guide you might be able to get some ideas from on how to set it up
you will not be able to get the WOL to work as long as you require a password to boot. if you need full disk encryption, look into storing the encryption password in TPM, enable secure boot and password protect bios/system setup with a locked boot order.
as long as your system requires input from you to start, it will always stop at the luks unlock step, unless you find another place to store the keys to allow unlocking without user input.
it could work if the computer suspended instead of powering off, but then it will fail again in a case of power loss.
hope this helps a bit, and good luck. seems like a fun project.
Er jo en hel Lemmy instans for Danmark her, så det finnes nok flere av osw, og ja, jeg er fra Norge 🙂
Håper det ordner seg når du får installert ny font når du har tid og anledning til det 🙂