• 1 Post
  • 25 Comments
Joined 1 year ago
cake
Cake day: June 22nd, 2023

help-circle



  • It’s all with respect to humans. Humans aren’t making the bird nests, so they’re natural, not man-made. Our houses don’t over naturally, we build them.

    From the bird’s perspective, sure, nests might be bird-made and humans are part of nature. But at humans, we’ve also done a ton to shape the world and separate ourselves from nature. If your house were a fire-heated lean-to in the woods, there might be less a distinction between it and “out in nature,” but if you’re living in a city or town, your immediate surroundings probably have been heavily constructed and modified by humans.








  • I also discovered this. I was panicking a little bit when I started smelling what seemed like sewage in my basement. In a 100 year old house, I was wondering what broke. After a few hours, I figured out that there were potatoes rotting in the pantry, which was more open to the basement than it was to the main floor of the house - so all the smell sank down there. It was honestly a relief.






  • Oh boy, I keep a page just for this!.

    I need to update it (for example, Arachne perimeters in PrusaSlicer now let you print extra thin perimeters), but it’s useful to have a reference for common tolerances/dimensions like screw holes.

    But a couple of my little additional pet peeves:

    • Don’t put fillets on the underside of prints (against the bed). The nearly-flat angle always droops and looks bad. Use a chamfer instead, or make a fillet that actually starts at 30° from horizontal.
    • The weakest direction is between layers. Design your part such that you can print it in an orientation where the thin/weak parts aren’t printed where the layer lines can snap (eg, print it flat vs vertical)
    • Just like the straight lines inside screw head holes, thinking ahead in your design can prevent/minimize the need for support material. The earlier you start thinking about this in you design, the easier it will be. For example, can a part be designed with a 30° slope on an underside instead of being flat? Can you think about your print orientation early in the design process to avoid overhangs?
    • Chamfer of fillet inside corners, if it’s a structural part. This will greatly reduce stress concentrations.

    Personally, I don’t use 3 perimeters on most of my prints. On my prusa, they look totally fine with 2 perimeters. I only switch to 3 if I need the strength (which also almost always means I’m printing in PETG, rather than PLA, FWIW).