It’s gotten so bad that they don’t want you to realize you’re looking at the second page

I can’t personally recommend anytihing excep this site https://www.rtings.com/headphones/reviews/best/noise-cancelling-earbuds Their reviews go very deep and use actual measurements instead of human opinions

https://m.youtube.com/watch?v=9q0T7MhfN6k solution at about minute 3 Silicone becomes a bit more brittle at high temperatures so that is one option, otherwise you could try putting the brush in the freezer overnight so that the silicone becomes more brittle while cold. Mind that I know nothing about knots and handles, so I don’t know what could ruin them

deleted by creator

Tell me more

Dismaine

Do you by chance mean Lebensraum? I have heard of it before but I don’t remember the context exactly

I think the mitsubishi space star could be an answer, base model doesn’t have a smart anything, but it might not be available where you are

Definitely at least a side of half a weel

Defnitely a wheel, not necessarily a car

Mi sa che il tuo capo è l’ultima volta che fa del sarcasmo con clienti del genere

A calzone, the ends aren’t open. A wellington is usually shown cut but that doesn’t change its identification

Don’t know if in similar vein at all, but corridor and corridor crew

You probably haven’t seen this yet https://www.youtube.com/watch?v=zd6WtTUf-30

Definitely jump in so you get some commons and uncommons to get some bulk for your collection, then some constructed so you up a little your rank and get the end of the season rewards

Io spero sinceramente che questo sia ragebait, perchè certe cose non si fanno

I’d advise on holdin off draft until you’ve built some decks on your own, since deckbuilding is the most important skill in draft. Try to find the flaws each deck has and which cards are stronger than others(considering many possible cases, otherwise you’ll just find situational ones). Last but not least: the less cards your deck has, the higher the probability of drawing that very strong one early.

For your first printer I’d actually advise for buying a used one: it’s cheaper and you wouldn’t support a chinese manufacturer even if you bought one of their printers

Quality control aka how well the printer and its components are tested after production