Pretty basic question but I am struggling to find the words to get the correct search result. The soldering iron I bought came with very narrow tips that I think are supposed to be used for circuit boards and components.

When I attempt to solder lines from a USB cord together the line never gets warm enough.

I remember in the past soldering copper lines together from an appliance with no issue so I don’t think I’m doing anything wrong in terms of technique but who knows?

  • CorrodedCranium@lemmy.fmhy.mlOP
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    This was a few months ago so I can’t recall a lot of the specifics unfortunately.

    What I can recall was using a 90w Ali Express soldering iron with a conical tip to solder a damaged original Xbox controller cable. The leaded solder seemed slow to melt on the tip but wouldn’t melt to the wire when I applied heat on the under side.

    Sorry I can’t tell you more. I was looking to do some practice this weekend and wanted to know if I should be ordering a thicker tip or something.

    • Rolivers@discuss.tchncs.de
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      Wattage does not mean how hot it gets, it means how fast it gets to the desired temperature. Also Chinese vendors tend to exaggerate greatly with specifications, especially with cheap products.

    • cmnybo@discuss.tchncs.de
      link
      fedilink
      English
      arrow-up
      2
      arrow-down
      1
      ·
      1 year ago

      The temperature is set too low. The solder should melt almost instantly when applied to the tip if the iron is set to 350°C.

      Those fine point conical tips that typically come with soldering irons are terrible. Get a 2-3mm chisel tip, that will be suitable for most soldering jobs.