When I run smartctl -Ai -d megaraid,0 /dev/sda I only get the following output:

smartctl 6.5 2016-05-07 r4318 [x86_64-linux-4.19.0+1] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF INFORMATION SECTION ===
Vendor:               NVMe
Product:              SAMSUNG MZQLB7T6
Revision:             502Q
Compliance:           SPC-5
User Capacity:        7,681,501,126,656 bytes [7.68 TB]
Logical block size:   512 bytes
LU is resource provisioned, LBPRZ=0
Rotation Rate:        Solid State Device
Logical Unit id:      REDACTED
Serial number:        REDACTED
Device type:          disk
Transport protocol:   SAS (SPL-3)
Local Time is:        Wed Oct 26 REDACTED
SMART support is:     Available - device has SMART capability.
SMART support is:     Enabled
Temperature Warning:  Enabled

=== START OF READ SMART DATA SECTION ===
Current Drive Temperature:     33 C
Drive Trip Temperature:        86 C

I expected to see stuff like Total_Writes_GiB (TBW) or other “Vendor Specific SMART Attributes” I get on other systems, including the SMART log.

How can I get the complete SMART data here? Is it possible to use nvme to show the statistics as it seems to be an NVMe-attached drive? nvme list only shows me the disks not connected through the MegaRAID controller…