//Edit: It’s a SAS drive. thanks for the help :))

I bought two of these a long time ago, and I recently tried to connect them to a SATA III connector without luck. The size seems to match up, but the block between the two pin segments seems to block it from connecting with SATA III.

Can you help me figure out what kind of adaptor I need ? :))

    • SJ0@lemmy.fbxl.net
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      Almost guaranteed that’s what it is.

      A modern serial attached SCSI drive. It’s been a standard on servers for years.

      • dack@lemmy.world
        link
        fedilink
        English
        arrow-up
        4
        ·
        1 year ago

        No. SAS is a different protocol and requires a different host controller. SAS controllers can typically handle SATA drives, but not the other way around.

        If this is for a server or desktop machine, you could install a PCIe SAS HBA.

  • Beko Pharm@discuss.tchncs.de
    link
    fedilink
    English
    arrow-up
    5
    ·
    1 year ago

    Why yes it’s a SAS drive. You can find that in some NAS models for home use too. Otherwise this is usually server land.

    The thing with HBAs is that you usually only get virtual disks on the system side because the controller masks the real disks. This is not really needed any more since modern filesystems can do RAID functionality too - and even better and faster - but that does require direct access to the drive.

    Many controllers can be patched though or come with a pass through (JBOD) mode out of the box, which allows you to use that kind of drive directly again. Such drives can be obtained used for cheap too so this may be a feasible option to extend the possible amount of drives for a desktop computer at home too a lot. Most controllers support 4-8 devices.

  • Brgor@lemmy.zip
    link
    fedilink
    English
    arrow-up
    5
    ·
    1 year ago

    That’s a SAS connector, but unfortunately it won’t work with your computer without a SAS card called an HBA or Host Bus Adapter.

  • stickmanmeyhem@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    It’s a 2.5” SAS drive. They’re usually used in servers and typically spin a lot faster than consumer SATA drives. You won’t be able to use it in your PC unless you buy an HBA card and some adapters.

    • RAM@discuss.tchncs.deOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      thank you :))

      do you know why SAS HBAs are so expensive ? 🥲 is it possible to get a cheap one ?

      • cmnybo@discuss.tchncs.de
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        I got a used 8 port card from ebay for about $20 a few years ago. I had to flash different firmware to it using a DOS boot disk to disable raid though. It’s an obsolete card, but it’s been working fine in my NAS.

  • dankm@lemmy.ca
    link
    fedilink
    English
    arrow-up
    1
    arrow-down
    4
    ·
    1 year ago

    That looks like one of the notebook SATA variants. It’s SATA & power combined in one connector, and passive adapters used to be readily available.